All Victory Models OIL CHANGE KIT

download
1. Warmup the engine for several minutes. 2. Stop the engine. Securely support the machine on its sidestand. IMPORTANT: Take the proper precautions sot hem achinedoes not tip while working on it. Place an oil pan under the engine and loosen the oil fill cap/ dipstick. 3. Remove the drain plug (1) and drain the oil. 4. Remove the oil filter (2). 5. Reinstall the drain plug with anew sealing washer or O-rIngfromthekit. Torque drain plug to the specification listed in the Owner’sManualorService Manual. 6. Apply alight coat of engine oil to theO-ring of the new oil filter. Make sure the O-ring is seated properly in the groove on the filter. 7. Install filter and tighten it 3/4 of a turn after O-ring contacts engine case. 8. Remove the fill cap/dipstick and fill the engine with the amount of oil recommended in the Owner’sManualor Service Manual and reinstall the dipstick /filler cap. 9. Start the engine and warm it up for several minutes and check for leaks. If any leaks are found, stop the engine and determine the source of the problem before starting the engine again. Contact your Victory dealer if you cannot determine the source of the leak. NOTE: After the engine is started, the oil indicator light should go off. If the indicator light flickers or remains on, immediately stop the engine and take your motorcycle to a Victory dealer. 10. Stop the engine and inspect oil level (refer to the Owner’sManualorService Manual). 11. Install the fill cap/dipstick and tighten securely